Ford F-350 Super Duty 2008-2010 Workshop Service Repair Manual
Ford F-350 Super Duty 2008-2010 Service Manual
Diagnostic Methods:
Diagnostic Methods provides information to support diagnosing Ford vehicles. Diagnostic strategies,
diagnostic tool support information, and advanced circuit testing methods are included. REFER to Diagnostic
Methods .
Diagnostic Routines
Diagnostic Routines provide information to determine the root cause of concerns addressed in either a DTC
Chart or Symptom Chart. Each Diagnostic Routine contains:
Diagnostic Overview:
- Wiring Diagram References (as applicable)
- Normal Operation and Fault Conditions
- Visual Inspection and Diagnostic Pre-checks
- Tool Table (as applicable)
- Material Table (as applicable)
- Pinpoint Test Steps about brake car
- Component Tests
- Component Tests are used to separately analyze a single common component in a system. The test will
- determine if the part is functioning correctly.
- Mechanical Procedures Such As Removal and Installation
- Reuse Of Fasteners, Seals, Or Gaskets
- The following is a list of assumptions made in the reuse of fasteners, seals, or gaskets.
- Seals and gaskets must be replaced unless otherwise specified.
- Standard fasteners are reused unless otherwise specified.
Ford F-350 Super Duty 2008-2010 Workshop Service Repair Manual
Positions 5 through 7 indicate vehicle line, series and body type.
- F20 — F-250, Regular Cab, rear wheel drive (RWD), single rear wheels
- F21 — F-250, Regular Cab, four wheel drive (4WD), single rear wheels
- F30 — F-350, Regular Cab, RWD, single rear wheels
- F31 — F-350, Regular Cab, 4WD, single rear wheels
- F32 — F-350, Regular Cab, RWD, dual rear wheels
- F33 — F-350, Regular Cab, 4WD, dual rear wheels
- F34 — F-350, Regular Cab (Chassis Cab), RWD, single rear wheels
- F35 — F-350, Regular Cab (Chassis Cab), 4WD, single rear wheels
- F36 — F-350, Regular Cab (Chassis Cab), RWD, dual rear wheels
- F37 — F-350, Regular Cab (Chassis Cab), 4WD, dual rear wheels
Fasteners with self-locking features must be replaced unless otherwise noted. Reminder text may or
may not be included with the procedure step. Examples of fastener coatings or fasteners with
mechanical locking (with the locking features highlighted yellow) are shown in illustration 1.
Torque to yield bolts (bolts with more than one stage of tightening torque and a final torque angle
specification) must be discarded and new torque to yield bolts installed unless otherwise stated within
the procedure.